30 Hawk 1LP Family Installation Guide, Rev. D
continued from previous page
TP Position A ("N" family models only)
On | This horizontally positioned jumper across the |
| two TP positions nearest PCB edge, connects |
| terminator power from SCSI bus I/O pin 26 to the |
| drive's internal terminators. |
Off | See above explanations for TP jumpers. |
J5
Jumper
Installation Jumper Function Description
A0,A1,A2* Drive ID on SCSI Bus (J6 may be used in- stead). The drive ID is binary coded positionwise i.e., jumper in position A2 is drive ID 4, in position A1 is ID 2, position A0 is ID 1 and no jumpers is ID 0. Default is ID = 0.
J6
Jumper
Installation Jumper Function Description
A2,A1,A0* Drive ID on SCSI bus. Either J5 or J6 (optional) may be used to select drive ID. Both should not be used at the same time, because at some future time when the ID is changed the user could fail to configure both J5 and J6 the same. Default is ID = 0. "NC" models can select drive ID via the 80 pin SCSI I/O connector.
