22 Hawk 1LP Family Installation Guide, Rev. D
Drive configuration
Each disc drive has one or more option select header connectors on the back, side or front where jumper plugs are installed to select the way that the drive is to be configured or to select its ID on the I/O bus. See notes following Figure 3b.
Hawk 1LP family N/ND models (50 pin SCSI I/O)
On Model N/ND drives either J6 (on the front of the drive) or J5 (on the side behind the DC Power connec- tor) may be used to set the drive ID. To avoid possible incorrect ID setting, do not use both J5 and J6 for ID selection. The following figures show where these headers are located on the different drives covered by this manual. See notes following Figures 3a and 3b where explanations are given about the purpose of each jumper and specify the standard factory (called "default") settings of these jumpers (i.e., settings used for most common single drive application). Changes to these settings should be made only if it is known that the system requires a different configuration.
