ZyXEL Communications HS100/HS100W Configuring WWW, Remote Management and NAT, System Timeout

HomeSafe User’s Guide

3.The IP address in the Secured Client IP field does not match the client IP address. If it does not match, the HomeSafe will disconnect the session immediately.

4.There is already another remote management session with an equal or higher priority running. You may only have one remote management session running at one time.

5.There is a firewall rule that blocks it.

14.1.2Remote Management and NAT

When NAT is enabled:

¾ Use the HomeSafe’s WAN IP address when configuring from the WAN. ¾ Use the HomeSafe’s LAN IP address when configuring from the LAN.

14.1.3System Timeout

There is a default system management idle timeout of five minutes (three hundred seconds). The HomeSafe automatically logs you out if the management session remains idle for longer than this timeout period. The management session does not time out when a statistics screen is polling.

You can change the timeout period in the System screen

14.2 Configuring WWW

To change your HomeSafe’s World Wide Web settings, click REMOTE MGMT to display the

WWWscreen.

Figure 14-1 Remote Management : WWW

The following table describes the labels in this screen.

	Table 14-1 Remote Management : WWW
LABEL	DESCRIPTION
Server Port	You may change the server port number for a service if needed, however you must
	use the same port number in order to use that service for remote management.

14-2 Remote Management Screens