ZyXEL Communications HS100/HS100W manual Remote Node Filter, SUA Only, Many-to-One and Server

HomeSafe User’s Guide

Table 22-4 Remote Node Network Layer Options

FIELD	DESCRIPTION	EXAMPLE
My WAN Addr	This field is applicable to PPPoE and PPTP encapsulations only. Some
	implementations, especially the UNIX derivatives, require the WAN link to
	have a separate IP network number from the LAN and each end must
	have a unique address within the WAN network number. If this is the
	case, enter the IP address assigned to the WAN port of your HomeSafe.
	Note that this is the address assigned to your local HomeSafe, not the
	remote router.
Network	Network Address Translation (NAT) allows the translation of an Internet	SUA Only
Address	protocol address used within one network (for example a private IP	(default)
Translation	address used in a local network) to a different IP address known within
	another network (for example a public IP address used on the Internet).
	Choose None to disable NAT.
	Choose SUA Only if you have a single public IP address. SUA (Single
	User Account) is a subset of NAT that supports two types of mapping:
	Many-to-One and Server.
	Choose Full Feature if you have multiple public IP addresses. Full
	Feature mapping types include: One-to-One, Many-to-One(SUA/PAT),
	Many-to-Many Overload, Many- One-to-One and Server. When you
	select Full Feature you must configure at least one address mapping set!
	See the NAT chapter for a full discussion on this feature.
Metric	Enter a number from 1 to 15 to set this route’s priority among the	1
	HomeSafe’s routes (see the Metric section in the WAN and Dial Backup
	Setup chapter) The smaller the number, the higher priority the route has.
Private	This field is valid only for PPTP/PPPoE encapsulation. This parameter	No
	determines if the HomeSafe will include the route to this remote node in its
	RIP broadcasts. If set to Yes, this route is kept private and not included in
	RIP broadcast. If No, the route to this remote node will be propagated to
	other hosts through RIP broadcasts.
RIP Direction	Press [SPACE BAR] and then [ENTER] to select the RIP direction from	None
	Both/ None/In Only/Out Only. See the LAN Setup chapter for more	(default)
	information on RIP. The default for RIP on the WAN side is None. It is
	recommended that you do not change this setting.
Version	Press [SPACE BAR] and then [ENTER] to select the RIP version from	N/A
	RIP-1/RIP-2B/RIP-2M or None.
Multicast	IGMP (Internet Group Multicast Protocol) is a network-layer protocol used	None
	to establish membership in a Multicast group. The HomeSafe supports	(default)
	both IGMP version 1 (IGMP-v1) and version 2 (IGMP-v2). Press [SPACE
	BAR] to enable IP Multicasting or select None to disable it. See the LAN
	Setup chapter for more information on this feature.

Once you have completed filling in Menu 11.3 Remote Node Network Layer Options, press [ENTER] at the message “Press ENTER to Confirm...” to save your configuration and return to menu 11, or press [ESC] at any time to cancel.

22.4 Remote Node Filter

Move the cursor to the field Edit Filter Sets in menu 11.1, and then press [SPACE BAR] to set the value to Yes. Press [ENTER] to open Menu 11.5 - Remote Node Filter.

22-6 Remote Node Configuration