ZyXEL Communications HS100/HS100W manual Configuring the Pptp Client, Server

HomeSafe User’s Guide

	Table 21-1 Menu 4: Internet Access Setup (Ethernet)
FIELD	DESCRIPTION
Retype to Confirm	Enter your password again to make sure that you have entered is correctly.
Login Server	The HomeSafe will find the RoadRunner Server IP if this field is left blank. If it does
	not, then you must enter the authentication server IP address.
Relogin Every	This field is available when you select Telia Login in the Service Type field.
(min)	The Telia server logs the HomeSafe out if the HomeSafe does not log in
	periodically. Type the number of minutes from 1 to 59 (30 recommended) for the
	HomeSafe to wait between logins.
IP Address	If your ISP did not assign you a fixed IP address, press [SPACE BAR] and then
Assignment	[ENTER] to select Dynamic, otherwise select Static and enter the IP address and
	subnet mask in the following fields.
IP Address	Enter the (fixed) IP address assigned to you by your ISP (static IP address
	assignment is selected in the previous field).
IP Subnet Mask	Enter the subnet mask associated with your static IP.
Gateway IP	Enter the gateway IP address associated with your static IP.
Address
Network Address	Network Address Translation (NAT) allows the translation of an Internet protocol
Translation	address used within one network (for example a private IP address used in a local
	network) to a different IP address known within another network (for example a
	public IP address used on the Internet).
	Choose None to disable NAT.
	Choose SUA Only if you have a single public IP address. SUA (Single User
	Account) is a subset of NAT that supports two types of mapping: Many-to-Oneand
	Server.
	Choose Full Feature if you have multiple public IP addresses. Full Feature
	mapping types include: One-to-One, Many-to-One(SUA/PAT), Many-to-Many
	Overload, Many- One-to-One and Server. When you select Full Feature you must
	configure at least one address mapping set!
	Please see the NAT chapter for a more detailed discussion on the Network Address
	Translation feature.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save your configuration, or press [ESC] at any time to cancel.

21.3 Configuring the PPTP Client

)The HomeSafe supports only one PPTP server connection at any given time.

To configure a PPTP client, you must configure the My Login and Password fields for a PPP connection and the PPTP parameters for a PPTP connection.

After configuring My Login and Password for PPP connection, press [SPACE BAR] and then [ENTER] in the Encapsulation field in Menu 4 -Internet Access Setup to choose PPTP as your encapsulation option. This brings up the following screen.

21-2 Internet Access