ZyXEL Communications HS100/HS100W manual Chapter Static Route Screens, Static Route Overview

HomeSafe User’s Guide

Chapter 10

Static Route Screens

This chapter shows you how to configure static routes for your HomeSafe.

10.1 Static Route Overview

Each remote node specifies only the network to which the gateway is directly connected, and the HomeSafe has no knowledge of the networks beyond. For instance, the HomeSafe knows about network N2 in the following figure through remote node router R1. However, the HomeSafe is unable to route a packet to network N3 because it doesn't know that there is a route through the same remote node router R1 (via gateway router R2). The static routes are for you to tell the HomeSafe about the networks beyond the remote nodes.

Figure 10-1 Example of Static Routing Topology

10.2 Configuring IP Static Route

Click STATIC ROUTE to open the screen as shown next.

Figure 10-2 Static Route

The following table describes the labels in this screen.

NAT Screens 10-1