ZyXEL Communications HS100/HS100W TCP/IP Filter Rule, Field Description Options, Less, Equal

HomeSafe User’s Guide

To configure TCP/IP rules, select TCP/IP Filter Rule from the Filter Type field and press [ENTER] to open Menu 21.1.1.1 - TCP/IP Filter Rule, as shown next.

Menu 21.1.1.1 - TCP/IP Filter Rule

Filter #: 1,1
Filter Type=	TCP/IP Filter Rule
Active= Yes
IP Protocol=	0	IP	Source Route= No
Destination: IP Addr=			0.0.0.0
	IP Mask=		0.0.0.0
	Port #= 137
	Port # Comp= Equal
Source: IP Addr=			0.0.0.0
	IP Mask=		0.0.0.0
	Port #=
	Port # Comp= None
TCP Estab= N/A
More= No		Log= None
Action Matched= Check			Next Rule

Action Not Matched= Check Next Rule

Press ENTER to Confirm or ESC to Cancel:

Figure 27-6 Menu 21.1.1.1 TCP/IP Filter Rule

The following table describes how to configure your TCP/IP filter rule.

Table 27-3 TCP/IP Filter Rule

FIELD	DESCRIPTION	OPTIONS
Active	Press [SPACE BAR] and then [ENTER] to select Yes to	Yes
	activate the filter rule or No to deactivate it.	No
IP Protocol	Protocol refers to the upper layer protocol, e.g., TCP is 6, UDP	0-255
	is 17 and ICMP is 1. Type a value between 0 and 255. A value
	of 0 matches ANY protocol.
IP Source Route	Press [SPACE BAR] and then [ENTER] to select Yes to apply	Yes
	the rule to packets with an IP source route option. Otherwise	No
	the packets must not have a source route option. The majority
	of IP packets do not have source route.
Destination
IP Address	Enter the destination IP Address of the packet you wish to	0.0.0.0
	filter. This field is ignored if it is 0.0.0.0.
IP Mask	Enter the IP mask to apply to the Destination: IP Addr.	0.0.0.0
Port #	Enter the destination port of the packets that you wish to filter.	0-65535
	The range of this field is 0 to 65535. This field is ignored if it is
	0.
Port # Comp	Press [SPACE BAR] and then [ENTER] to select the	None
	comparison to apply to the destination port in the packet	Less
	against the value given in Destination: Port #.	Greater
		Equal
		Not Equal
Source
IP Address	Enter the source IP Address of the packet you wish to filter.	0.0.0.0
	This field is ignored if it is 0.0.0.0.
IP Mask	Enter the IP mask to apply to the Source: IP Addr.	0.0.0.0

Filter Configuration 27-5