ZyXEL Communications HS100/HS100W manual Chapter Menu 2 WAN Setup, Introduction to WAN

HomeSafe User’s Guide

Chapter 19

Menu 2 WAN Setup

This chapter describes how to configure the WAN using menu 2.

19.1 Introduction to WAN

This chapter explains how to configure settings for your WAN port.

19.2 WAN Setup

From the main menu, enter 2 to open menu 2.

Menu 2 - WAN Setup

MAC Address:

Assigned By= Factory default

IP Address= N/A

Press ENTER to Confirm or ESC to Cancel:

Figure 19-1 Menu 2 WAN Setup

The following table describes the fields in this menu.

Table 19-1 Menu 2 WAN Setup

FIELD	DESCRIPTION
MAC Address
Assigned By	Press [SPACE BAR] and then [ENTER] to choose one of two methods to assign a
	MAC Address. Choose Factory Default to select the factory assigned default MAC
	Address. Choose IP address attached on LAN to use the MAC Address of that
	computer whose IP you give in the following field.
IP Address	This field is applicable only if you choose the IP address attached on LAN method in
	the Assigned By field. Enter the IP address of the computer on the LAN whose MAC
	you are cloning.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save your configuration, or press [ESC] at any time to cancel.

Menu 2 WAN Setup 19-1