ZyXEL Communications HS100/HS100W manual Traffic Redirect Setup

HomeSafe User’s Guide

Use menu 11.5 to specify the filter set(s) to apply to the incoming and outgoing traffic between this remote node and the HomeSafe to prevent certain packets from triggering calls. You can specify up to 4 filter sets separated by commas, for example, 1, 5, 9, 12, in each filter field. Note that spaces are accepted in this field. For more information on defining the filters, please refer to the Filters chapter. For PPPoE or PPTP encapsulation, you have the additional option of specifying remote node call filter sets.

Menu 11.5 - Remote Node Filter

Input Filter Sets: protocol filters=

device filters= Output Filter Sets: protocol filters= device filters=

Enter here to CONFIRM or ESC to CANCEL:

Figure 22-5 Menu 11.5: Remote Node Filter (Ethernet Encapsulation)

Menu 11.5 - Remote Node Filter

Input Filter Sets: protocol filters=

device filters= Output Filter Sets: protocol filters= device filters=

Call Filter Sets: protocol filters=

device filters=

Enter here to CONFIRM or ESC to CANCEL:

Figure 22-6 Menu 11.5: Remote Node Filter (PPPoE or PPTP Encapsulation)

22.4.1 Traffic Redirect Setup

Configure parameters that determine when the HomeSafe will forward WAN traffic to the backup gateway using Menu 11.6 — Traffic Redirect Setup.

Menu 11.6 - Traffic Redirect Setup

Active= Yes

Configuration:

Backup Gateway IP Address= 0.0.0.0

Metric= 14

Check WAN IP Address= 0.0.0.0

Fail Tolerance= 2

Period(sec)= 5

Timeout(sec)= 3

Press ENTER to Confirm or ESC to Cancel:

Figure 22-7 Menu 11.6: Traffic Redirect Setup

The following table describes the fields in this screen.

Remote Node Configuration 22-7