ZyXEL Communications HS100/HS100W manual Remote Management Snmp

HomeSafe User’s Guide

	Figure 14-6 Remote Management : SNMP
The following table describes the labels in this screen.
	Table 14-5 Remote Management : SNMP
LABEL	DESCRIPTION
SNMP Configuration
Get Community	Enter the Get Community, which is the password for the incoming Get and GetNext
	requests from the management station. The default is public and allows all requests.
Set Community	Enter the Set community, which is the password for incoming Set requests from the
	management station. The default is public and allows all requests.
Trusted Host	If you enter a trusted host, your HomeSafe will only respond to SNMP messages
	from this address. A blank (default) field means your HomeSafe will respond to all
	SNMP messages it receives, regardless of source.
Trap
Community	Type the trap community, which is the password sent with each trap to the SNMP
	manager. The default is public and allows all requests.
Destination	Type the IP address of the station to send your SNMP traps to.
SNMP
Service Port	You may change the server port number for a service if needed, however you must
	use the same port number in order to use that service for remote management.

14-8 Remote Management Screens