ZyXEL Communications HS100/HS100W manual Configuring Route Entry, Static Route Edit

HomeSafe User’s Guide

	Table 10-1 Static Route
LABEL	DESCRIPTION
#	Number of an individual static route.
Name	Name that describes or identifies this route.
Active	This field shows whether this static route is active (Yes) or not (No).
Destination	This parameter specifies the IP network address of the final destination. Routing is
	always based on network number.
Gateway	This is the IP address of the gateway. The gateway is an immediate neighbor of your
	HomeSafe that will forward the packet to the destination. On the LAN, the gateway
	must be a router on the same segment as your HomeSafe; over the WAN, the
	gateway must be the IP address of one of the remote nodes.
Edit	Select a static route index number and then click Edit to set up a static route on the
	HomeSafe.

10.2.1 Configuring Route Entry

Select a static route index number and click Edit. The screen shown next appears. Fill in the required information for each static route.

	Figure 10-3 Static Route: Edit
The following table describes the labels in this screen.
	Table 10-2 Static Route: Edit
LABEL	DESCRIPTION
Route Name	Enter the name of the IP static route. Leave this field blank to delete this static route.
Active	This field allows you to activate/deactivate this static route.
Destination IP	This parameter specifies the IP network address of the final destination. Routing is
Address	always based on network number. If you need to specify a route to a single host, use
	a subnet mask of 255.255.255.255 in the subnet mask field to force the network
	number to be identical to the host ID.
IP Subnet Mask	Enter the IP subnet mask here.
Gateway IP	Enter the IP address of the gateway. The gateway is an immediate neighbor of your
Address	HomeSafe that will forward the packet to the destination. On the LAN, the gateway
	must be a router on the same segment as your HomeSafe; over the WAN, the
	gateway must be the IP address of one of the Remote Nodes.

10-2 NAT Screens