ZyXEL Communications HS100/HS100W manual Outgoing Authentication Protocol, Nailed-Up Connection

HomeSafe User’s Guide

Table 22-1 Menu 11.1 Remote Node Profile for Ethernet Encapsulation

FIELD

DESCRIPTION

EXAMPLE

Once you have configured this menu, press [ENTER] at the message “Press ENTER to Confirm...” to save your configuration, or press [ESC] at any time to cancel.

22.2.2 PPPoE Encapsulation

The HomeSafe supports PPPoE (Point-to-Point Protocol over Ethernet). You can only use PPPoE encapsulation when you’re using the HomeSafe with a DSL modem as the WAN device. If you change the Encapsulation to PPPoE, then you will see the next screen. Please see the appendix for more information on PPPoE.

Menu 11.1 - Remote Node Profile

Rem Node Name= MyISP	Route= IP
Active= Yes	Apply Alias= None
Encapsulation= PPPoE	Edit IP= No
Service Type= Standard	Telco Option:
Service Name=	Allocated Budget(min)= 0
Outgoing:	Period(hr)= 0
My Login=	Schedules=
My Password= ********	Nailed-Up Connection= No
Retype to Confirm= ********
Authen= CHAP/PAP	Session Options:
	Edit Filter Sets= No
	Idle Timeout(sec)= 100
	Edit Traffic Redirect= No

Press ENTER to Confirm or ESC to Cancel:

Figure 22-2 Menu 11.1 Remote Node Profile for PPPoE Encapsulation

Outgoing Authentication Protocol

Generally speaking, you should employ the strongest authentication protocol possible, for obvious reasons. However, some vendor’s implementation includes a specific authentication protocol in the user profile. It will disconnect if the negotiated protocol is different from that in the user profile, even when the negotiated protocol is stronger than specified. If you encounter a case where the peer disconnects right after a successful authentication, please make sure that you specify the correct authentication protocol when connecting to such an implementation.

Nailed-Up Connection

A nailed-up connection is a dial-up line where the connection is always up regardless of traffic demand. The HomeSafe does two things when you specify a nailed-up connection. The first is that idle timeout is disabled. The second is that the HomeSafe will try to bring up the connection when turned on and whenever the connection is down. A nailed-up connection can be very expensive for obvious reasons.

Do not specify a nailed-up connection unless your telephone company offers flat-rate service or you need a constant connection and the cost is of no concern.

The following table describes the fields not already described in Table 22-1.

Remote Node Configuration 22-3