ZyXEL Communications HS100/HS100W manual Remote Management Limitations, LAN Only

HomeSafe User’s Guide

Table 33-1 Menu 24.11 – Remote Management Control

FIELD	DESCRIPTION	EXAMPLE
Port	This field shows the port number for the service or protocol. You may	23
	change the port number if needed, but you must use the same port
	number to access the HomeSafe.
Access	Select the access interface (if any) by pressing [SPACE BAR], then	LAN Only
	[ENTER] to choose from: LAN only, WAN only, ALL or Disable.	(default)
Secure Client	The default 0.0.0.0 allows any client to use this service or protocol to	0.0.0.0
IP	access the HomeSafe. Enter an IP address to restrict access to a client
	with a matching IP address.

Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to Cancel" to save your configuration, or press [ESC] to cancel.

33.1.1 Remote Management Limitations

Remote management over LAN or WAN will not work when:

1.A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or Web service.

2.You have disabled that service in menu 24.11.

3.The IP address in the Secure Client IP field (menu 24.11) does not match the client IP address. If it does not match, the HomeSafe will disconnect the session immediately.

4.There is an SMT console session running.

5.There is already another remote management session with an equal or higher priority running. You may only have one remote management session running at one time.

6.There is a firewall rule that blocks it.

33-2 Remote Management