ZyXEL Communications HS100/HS100W Fields in Menu 11.1 PPPoE Encapsulation Specific, Chap/Pap

HomeSafe User’s Guide

Table 22-2 Fields in Menu 11.1 (PPPoE Encapsulation Specific)

FIELD	DESCRIPTION	EXAMPLE
Service Name	If you are using PPPoE encapsulation, then type the name of your	poellc
	PPPoE service here. Only valid with PPPoE encapsulation.
Authen	This field sets the authentication protocol used for outgoing calls.	CHAP/PAP
	Options for this field are:
	CHAP/PAP - Your HomeSafe will accept either CHAP or PAP when
	requested by this remote node.
	CHAP - accept CHAP only.
	PAP - accept PAP only.
Telco Option
Allocated	The field sets a ceiling for outgoing call time for this remote node. The	0
Budget	default for this field is 0 meaning no budget control.	(default)
Period(hr)	This field is the time period that the budget should be reset. For	0
	example, if we are allowed to call this remote node for a maximum of 10	(default)
	minutes every hour, then the Allocated Budget is (10 minutes) and the
	Period(hr) is 1 (hour).
Schedules	You can apply up to four schedule sets here. For more details please
	refer to the Call Schedule Setup chapter.
Nailed-Up	This field specifies if you want to make the connection to this remote	No
Connection	node a nailed-up connection. More details are given earlier in this	(default)
	section.
Session
Options
Idle Timeout	Type the length of idle time (when there is no traffic from the HomeSafe	100 seconds
	to the remote node) in seconds that can elapse before the HomeSafe	(default)
	automatically disconnects the PPPoE connection. This option only
	applies when the HomeSafe initiates the call.

22.2.3 PPTP Encapsulation

If you change the Encapsulation to PPTP in menu 11.1, then you will see the next screen. Please see the appendix for information on PPTP.

Menu 11.1 - Remote Node Profile
Rem Node Name=	Route=
Active=	Apply Alias=
Encapsulation=	Edit IP=
Service Type=	Telco Option:
Service Name= N/A	Allocated Budget(min)=
Outgoing:	Period(hr)=
My Login=	Schedules=
My Password=	Nailed-Up Connection=
Retype to Confirm=
Authen=
PPTP My IP:	Session Options:
My IP Addr=	Edit Filter Sets=
My IP Mask=	Idle Timeout(sec)=
Server IP Addr=
Connection ID/Name=	Edit Traffic Redirect=
Press ENTER to Confirm	ESC to Cancel:
Figure 22-3 Menu 11.1 Remote Node Profilefor PPTP Encapsulation

The next table shows how to configure fields in menu 11.1 not previously discussed.

22-4 Remote Node Configuration