Seagate ST31200N/ND/NC, ST3620N/ND/NC manual Safety instructions

6 Hawk 1LP Family Installation Guide, Rev. D

Safety instructions

1.The disc drive(s) are to be installed in a customer supplied enclosure where the surrounding air does not exceed 50oC.

2.Four (4) 6-32 UNC-2A screws are required for installation. Maximum screw length into side of drive is 0.15 inches (3.81 mm). Maximum screw length into bottom is 0.20 in. (5.08 mm). Screw tightening torques is 8.0 lb-in (.90 NM) max with minimum thread engagement of 0.12 in (3.00 mm).

3.The power requirements are shown in the Product Information section.

4.The power supply must satisfy the safety require- ments for SELV (Safety Extra Low Voltage) cir- cuits.

5.Service is to be provided by trained Seagate ser- vice personnel.

6.The incorporation of the disc drives listed in this guide into a customer enclosure must meet the appropriate safety requirements of the country in which it is used (e.g. UL 1950, CAN/CSA-C22.2

No. 950-M89, DIN VDE 0805/05.90 and EN60950: 1988 (IEC 950).

Note

Power must be off when connecting or disconnecting.