Seagate ST31270A manual Medalist 1270 Installation Guide, July

22 Medalist 1270 Installation Guide, July 1995

driver must be turned off for you to open and use Windows. Use the Seagate replacement driver to restore 32-bit disk access capability. To open Windows and restore 32-bit disk access:

1.Press ENTER to open Windows.

2.Open the Main menu.

3.Open the Control Panel.

4.Open 386 Enhanced.

5.Select Virtual Memory.

6.Select Change.

7.Select 32-Bit Disk Access at the bottom of the screen to change its status.

8.Select OK. Follow the screen instructions to reboot.

You can re-establish the 32-bit disk access capability using the SEG32BIT.386 software as follows:

1.Load Windows.

2.Open the Program Manager menu and select File.

3.Select Run.

4.Insert the Seagate software diskette into the diskette drive.

5.In the command line box, type drive:stsetup.

6.Read the license agreement that appears on the screen. If you agree to the terms, select ACCEPT AGREEMENT to continue.

7.The next screen lists the features the SEG32BIT.386 driver supports. If your computer supports these features, they will be active in 32-bit disk access mode with SEG32BIT.386 for all drives that support them. Select Install Driver to continue.

8.After the driver is installed, you must enable the 32-bit disk access option in the Windows control panel to make it opera- tional. You can choose to enable the option now or later. If you choose to enable the driver now, the program opens the Windows main menu. Repeat steps 3 through 7 you used to disable the Windows 32-bit disk access driver to enable the SEG32BIT 32-bit disk access driver.