Seagate ST43401N/ND, ST43402ND user manual Mounting the drive

ST43401N/ND, ST43402ND User’s Manual, Rev. B 31

Mounting the drive

Caution. When installing the drive, observe all precautions listed under “Electrostatic discharge protection” in the preface. Failure to ob- serve these precautions can result in serious damage to electronic assemblies.

The drive may be secured to the enclosure using the tapped holes in either the sides or the bottom of the drive chassis. Figure 14 shows two of the three allowable orientations.

Note. The mounting screws must be completely engaged in the drive chassis, but the portion that extends into the chassis must not exceed

3.5mm (0.140 in) in length.

1.Place the drive into position in the enclosure and secure with four screws as shown in Figure 14.

•For bottom mounting, use 6-32 screws.

•For side mounting, use either 6-32 screws or M4 x .70 (metric) screws. There are tapped holes for each type.

2.Connect the 9-pin connector of the DC power cable to the output connector on the power supply. Connect the 4-pin connector of the same cable to the DC power connector J15 on the drive.

3.Connect the AC power cord to site power.