Seagate ST43402ND user manual Attaching an optional bezel, Attaching a bezel ST43401N/ND shown

30 ST43401N/ND, ST43402ND User’s Manual, Rev. B

Attaching an optional bezel

Use the following procedure to attach an optional bezel to the drive. The bezel is available as an accessory (see Section 4).

1.Remove the backing from the double-sticky tape attached to the rear surface of the bezel.

2.Orient the drive and bezel as shown in Figure 13.

3.Align the mounting bosses on the rear of the bezel to the matching holes in the drive chassis.

4.Press the bezel into place on the drive chassis ensuring that the mounting bosses extend through the chassis holes and that the double-sticky tape is in contact with both bezel and chassis.

5.Remove the selected LED (if present) from the LED socket and insert the LED plug from the bezel into the socket.

Control

Board

LED

Socket

LED

Plug

Chassis

Chassis Mounting Holes (2)

Active

LED

Bezel

Mounting Boss

Figure 13. Attaching a bezel (ST43401N/ND shown)