Seagate ST760211DE manual Conducted noise, Voltage tolerance Voltage tolerance including noise

2.7.2Conducted noise

Input noise ripple is measured at the host system power supply across an equivalent 15-ohm resistive load on the +3.3 volt line.

Using 3.3-volt power, the drive is expected to operate with a maximum of 70 mV peak-to-peak square-wave injected noise at up to 20 MHz.

Note. Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write current.

2.7.3Voltage tolerance Voltage tolerance (including noise):

3.3V ± 5%

8 Lyrion Series IDE Product Manual, Rev. E