Seagate STT8000A manual Setting jumpers, Jumper block and jumper settings

Chapter 3 Installation

Setting jumpers

Review the jumper settings to ensure that the jumpers are properly configured for your system. Figure 3-1 shows the location of the jumper block. Figure 3-2 shows the jumper block.

Note: Record your jumper settings prior to installation. They are not visible after the drive has been installed.

The default setting is Slave mode with a jumper over pin 3 and pin 4.

Your system setting may vary, so be sure to check your computer or ATAPI controller manual to determine the proper configuration choice for your system.

Figure 3-1

Location of jumper block and connectors

NOTE:

Bottom of drive shown.

JUMPER

BLOCK

PIN 1

IDE

CONNECTOR

IDE PIN 1

POWER

CONNECTOR

Figure 3-2

Jumper block and jumper settings

(TOP OF TAPE DRIVE)

1 3 5 7

2 4 6 8

NOT USED

MASTER

SLAVE

JUMPER ON

CABLE SELECT JUMPER OFF

Page 16 STT8000A Product Manual