SEAL 44/62 user manual Setting up the laminator in 4 steps, English

3.5 Setting up the laminator in 4 steps.

1.Remove the cardboard box and the plastic bag as described on the outside of the box.

2.Pick the box behind the laminator which contains the stand parts.

3.Mount the LH-side part of the stand as shown in next figure. (The LH-part is recognizable by a spring utility on the bracket.) Use two serrated washers and two socket screws M6x16 (see fig.2)

Do not tighten the screws completely.

English

Figure 2

4.Mount the RH-part of the stand onto the laminator as shown in figure 3. Use the serrated washers and the socket screws M6x16.

Do not tighten these screws completely.

Figure 3

Unpacking and Installation 9