1
Figure 12
6.1.2 Loading film onto a machine equipped with the cam lock system.
•Remove the desired supply shaft (top or bottom) by moving the cam handle (1) down to the open position.
•Lift the autogrip shaft out of the laminator.
•Slide the shaft into a material roll. Ensure that the rubber blocking cords are on the top and bottom of the shaft for easy loading.
CAUTION
Take care that the ends of the shaft do not become damaged during the loading and unloading.
6.1.3 Loading the unwind shaft into a machine equipped with the interlock bracket.
•Place the shaft, including the material, into the laminator by inserting it onto the left- hand supply shaft holder.
•Push the interlock bracket (see figure 11) upward with your finger before sliding the autogrip shaft further.
•Press against the spring pressure, until you can place the other end of the shaft onto the RH holder and onto the
•Center the material roll in the laminator.
•Rotate the unwind shaft until it locks onto the unwind brake.
6.1.4 Loading the unwind shaft into a machine equipped with the cam lock system.
•Place the shaft, including the material, onto the support blocks on the laminator.
•Move the cam handle up to the closed position.
•Center the material roll in the laminator.
•Rotate the unwind shaft until it locks onto the unwind brake.
18 | Application Processes |
