SEAL 44/62 user manual Slow-mode, Next, release the foot switch Finally release the forward button

4.2.1 Slow-mode

The machine has a slow-mode, which can be activated by pressing the foot switch. To maintain slow-mode, keep the foot switch pressed.

WARNING:

ONCE THE MACHINE IS RUNNING IN SLOW-MODE, INTERRUPTING THE PHOTOELECTRIC EYES DOES NOT STOP THE MACHINE; AN AUDIBLE BEEP WILL BE HEARD, AND THE ROLLER SPEED WILL BE DECREASED. RELEASING THE FOOT SWITCH WILL STOP THE MACHINE.

Changing from slow-mode to normal running mode without stopping (to prevent stop marks on the substrate):

•During slow mode (keep the foot switch pressed), press the ￿ (forward) button on the control panel. The machine will run at the pre-set speed.

•Next, release the foot switch.

•Finally release the ￿ (forward) button.

Changing from normal mode to slow-mode without stopping:

•Press the foot switch

Note: Releasing the foot switch will stop the machine.

4.2.2 Reversing the machine

To reverse the rotation of the rollers, press the ￿ (reverse) button. As long as the button is pressed, the machine will run in reverse direction, at a speed of 0.6 m/min for heated machines and 1.2 m/min for cold machines. Releasing the button will stop the machine.

WARNING:

CARE MUST BE TAKEN NOT TO HAVE LOOSE CLOTHING, LONG HAIR, JEWELLERY AND FINGERS PINCHED BETWEEN THE PULL ROLLERS AT THE REAR SIDE OF THE MACHINE.

The rotation of the rollers will stop when:

•The photoelectric eyes in front of the main rollers are interrupted

Note: This does NOT happen when the foot switch is used (slow-mode).

•An emergency stop button is pressed

•The foot switch is pressed for a short moment

•Excessive unwind tensions are set (the motor will be shut off electronically, press the stop button on the control panel to reset).

•The stop button on the control panel is pressed

14 Unit description