TABLE
SUPPORT
. Locate support lock handle among loose parts.
4.Install support lock handle from left side into table support. Raise table to working height by sliding it on the column and then tighten lock handle by hand.
iNSTALLiNG THE HEAD
CAUTION: The head assembly weighs about 45 pounds. Carefully lift head.
1, Remove protective covering from head,
2.Carefully lift head above column tube and slide it down on the column as far as it will go, Align head with table and base.
COLUMN
HEAD LOCK
SET SCREWS
3.Using a 4mm Hex "L" wrench tighten the head lock set screws on the right side of the head.
TABLE
COLUMN
HEAD
11
