Sears 113.21308 manual Meter specifications and e ectricaJ requirements, Motor SPECIFmCATmONS

meter specifications and e ectricaJ requirements

MOTOR SPECIFmCATmONS

This drill press is designed to use a 1725 RPtvl motor only. Do not use any motor that runs faster than t725 RPM. It is wired for operation on 110-120 volts, 60 Hz. alternating current.

WARNING: TO AVOID iNJURY FROM UNEX-

PECTED STARTUP, DO NOT USE BLOWER OR WASHING MACHINE MOTORS OR ANY MOTOR WiTH AN AUTOMATIC RESET OVERLOAD PRO-

TECTOR.

CONNECTING TO POWER

SOURCE OUTLET

This machine must be grounded while in use to protect the operator from electric shock.

Plug power cord into a 110-120V properly grounded type outlet protected by a 15-amp. dual element time delay or Circuit breaker.

NOT ALL OUTLETS ARE PROPERLY GROUNDED. IF YOU ARE NOT SURE THAT YOUR OUTLET, AS PICTURED BELOW, IS PROPERLY GROUNDED,

HAVE IT CHECKED BY A QUALIFIED ELECTRICIAN.

WARNING: TO AVOID ELECTRIC SHOCK, DO NOT TOUCH THE METAL PRONGS ON THE PLUG, WHEN INSTALLING OR REMOVING THE PLUG TO

OR FROM THE OUTLET.

WARNING: FAILURE TO PROPERLY GROUND THIS POWER TOOL CAN CAUSE ELECTRCUTION OR SERIOUS SHOCK, PARTICULARLY WHEN USED IN DAMP LOCATIONS, OR NEAR METAL PLUMBING. IF SHOCKED, YOUR REACTION COULD CAUSE YOUR HANDS TO HIT THE CUTTING TOOL.

IF POWER CORD IS WORN OR CUT, OR DAMAGED

IN ANY WAY, HAVE IT REPLACED IMMEDIATELY TO AVOID SHOCK OR FIRE HAZARD.

This power tool is equipped with a 3-conductor cord

and grounding type plug, approved by Underwriters' Laboratories and the Canadian Standards Association.

The ground conductor has a green jacket and is at- tached to the tool housing at one end and to the ground prong in the attachment plug at the other end.

This plug requires a mating 3-conductor grounded type outlet as shown,

If the outlet you are planning to use for this power tool is of the two prong type, DO NOT REMOVE OR ALTER THE GROUNDING PRONG IN ANY MANNER. Use an adapter as shown and always connect the grounding tug to known ground.

It is recommended that you have a qualified electrician replace the TWO prong outlet with a properly grounded THREE prong outlet.

An adapter as shown below is available for connecting plugs to 2-prong receptacles.

WARNING: THE GREEN GROUNDING LUG EX- TENDING FROM THE ADAPTER MUST BE CON-

NECTED TO A PERMANENT GROUND SUCH AS TO A PROPERLY GROUNDED OUTLET BOX.

GROUNDING LUG

SCR_\
3-PRONG	D_	_	MAKE SURE THISIS

ADAPTER

3-PRONG

PLUG

\

\

GROUNDING

PRONG

\

\

ALWAYS USE A

PROPERLY GROUNDED

OUTLET

Yourunitis _ruse on 120 votts, ithas a plugth_ looks like Me one above.

NOTE: The adapter illustrated is for use only if you already have a properly grounded 2-prong receptacle.

Adapter is not allowed in Canada by the Canadian Elec- trical Code.

The use of any extension cord will cause some loss of

power, To keep this to a minimum and to prevent over- heating and motor burn-out, use the table below to determine the minimum wire size (A.W.G.) extension cord. Use only 3 wire extension cords which have 3- prong grounding type plugs and 3-pole receptacles which accept the tools plug.

Extension Cord Length		WireSize A.W.G.
0-25	Feet	16
26-50	Feet	14
51-100Feet		12

6