iNSTALLiNG FEED HANDLES
!_ Locate three (3) feed handles among Iooseparts.
2Screw the feed handles tightly into the threaded hotes in the hub.
iNSTALLING THE CHUCK
1, Locate the chuck among loose parts.
2, Clean out the TAPERED HOLE in the chuck; clean the spindle nose with a clean cloth. Make sure there are no foreign particles sticking to the sur- faces. The slightest piece of dirt on the spindle nose or in the chuck will prevent the chuck from seating properly, This will cause the drill to "wobble."
NOTE: | If TAPERED HOLE | in the | chuck | is ex- | ,/ |
tremely | dirty, use a cleaning | solvent | on the | clean | |
cloth, |
|
|
|
|
|
3. Push the chuck up on the spindle nose as far as
it will | go. | ___SPINDLE | NOSE |
|
| ||
4: Turn | chuck sleeve clockwise and open jaws in |
| CHUCK |
chuck | completely. |
| SLEEVE |
|
|
5.Lightly tap the nose of the chuck with a piece of
wood to insure proper seating of the chuck on the spindle,
12
