Wiring Diagram ...........
/ARNING: To avoid fire or shock, use only recom- _ended service parts and reassemble exactly as
[originally assembled.
_J
Sears recommends the following accessories
Item | Sears Number |
Leg Set | ............................................................... |
Blades | See Sears Retail Store for 5" long |
| Plain End/Pin End blades |
Sears may recommend other accessories not listed in
manual, See your nearest Sears Store for other accesso- ries.
Troubleshooting..............................................
tpowerWARNING:sourceForoutletyourbeforeown safety,troubleshootingturn switchyour"OFF",scroll sawand. remove plug from I
L | PROBLEM | PROBABLE CAUSE | REMEDY SCHEDULED |
|
| ........................ | ' "i |
Breaking B'iades,
Motor will not run.
Vibration
NOTE: There will always be some vibration present when the saw is running because of the blade and arm movement,
Motor stops during cuts
1.Wrong tension
2.Over working blade.
3.Wrong btade application.
4.Twisting blade in wood. 1, Damaged cord or plug.
2, Damaged motor or control board.
1, Improper mounting of the
saw.
2.Unsuitable mounting sur- face.
3.Loose table
4.Loose motor mounting.
1: Aggressive feeding causes Current Protector to shut motor off.
1.Adjust blade tension.
2.Reduce feed rate.
3.Use narrow blades for cutting thin wood, wide blades for thicker wood.
4.Avoid side pressure on blade.
1.Replace damaged parts before using saw again.
2.Consult Sears Service. Any attempt to repair this motor or control board may create a HAZ- ARD unless repair is done by a qualified ser_ vice technician. Repair service is available at your nearest Sears Store.
1.See mounting instructions in this manual for proper mounting technique.
2.The heavier your workbench is, the less vibra- tion will occur, A plywood workbench wilt not be as good a work surface as the same size solid lumber. Use common sense in choosing a mounting surface.
3.Tighten table lock knob.
4.Tighten motor mounting screws,
1.Turn machine "OFF" and then back "ON" to continue cutting.
2. Slow down the feed rate ot material into blade.
21
