SCROLL SAW
Scroll Saw fails due to a defect in material or work-
RETURNING:THE CRAFTSMAN SCROLL SAW TO THE
E CENTER/DEPARTMENT IN THE UNITED
':IS USED IN THE UNITED STATES.
'ights which vary from state to state. IL: 60195
Safer
Safety is a combination of common sense, staying alert and knowing how your scroll saw works. Read this man, ual to understand this saw.
_Safety Signal Words
DANGER: means if the safety information is not followed someone will be seriously;injured or killed.
WARNING: means if
CAUTION: means if the safety information is not followed someone might be injured.
Before Using The Saw
the following steps are: corn pleted.
Assembly and alignment (See pages
Learn the:;:::useand function of the speed control ON-
OFF knob, bevel: lock knob, blade holders, blade sup, port, hold down, tension knob, and blade guard. (See pages14:16)
•Review and Understand at! safety instructions and operating procedures in this manual.
•Review of the maintenance:meth0ds for this saWi:(See page 20)
"Read the WARNING tabeJ!Seiow,found_n t_eba_eof the saw.
,WARNING
When Installing or Moving The Saw
dry indoor _place, prote=_edfrom rain:i Keep work area
well lighted.
To Avoid Injury from Unexpected Saw Movement:
•Turn saw off and unplug cord before moving the saw.
•Put the saw on a firm level surface where there is plenty of room for handling and properly supporting the workpiece.
•Support the saw so the table is level and the saw does not rock.
=Bolt the saw to the work surface if it tends to slip, walk, or slide during operations like cutting long heavy boards, or when using an auxiliary table.
oNEVER STAND ON TOOL. Serious injury could occur if the tool tips or you accidentally hit the cutting tool. Do not store anything above or near the tool where any- one might stand on the too! to reach them.
To Avoid Injury or Death from Electrical Shock:
°GROUND THE SAW, This saw has an approved 3 con- ductor cord and a
•Make sure your fingers do not touch the plug'smetal prongs when plugging or unplugging the saw.
Before Each Use:
InsPect your saw,
DISCONNECT THE SAW. To avoid injury from accidental starting, unplug the saw, turn the switch off and lock out the switch before changing the setup, removing covers, guards or blade.
CHECK DAMAGED PARTS. Check for:
-Alignment of moving parts.
•Binding of moving parts.
•Broken parts.
•Stable mounting.
°Any other conditions that may affect the way the saw works.
If any part is missing, bent or broken in any way, or an_ electrical parts don't work properly, turn the saw off aria
unplug the saw. REPLACE damaged, missing or failed parts before using the saw again.
