pastewax onthe wo_k:tabte will
cut _to'glide:smooth y across the
i
The motor bearings are permanently lubricated and require no further lubrication,
D0not attempt to oil the motor bearings or service the
m0t0rinternalpartsi
WARNING: ifthe power cord is worm, cut or dam- i aged inany way, have it replaced immediately.
t WARNING: To avoid fire or electrocution, reassem- i I bie electric parts with only approved service parts._
[Reassemble exactly as originally assembled. |
Arm Bearings
Lubricate the arm bearings after 10 _ours of use.
1. Turn saw on its side._
2_Squirt a generous amount 0f SAE 30 oil around the
3_ Let tl_e:oil soak inoVernight in this condition.
4;Next day repeat the above procedure for::the opposite
with this saw are
designed to give long service life. When one or both brushes become shorter than 1/4", replace both brushes.
1.Remove the brush cap using a 1/4" flat blade screw- driver.
NOTE: The brushes are spring loaded and may push against the brush cap as it releases.
2.Install the new brush assembly and reinstall the brush cap.
3.Use the cap to push the spring and brass end of the assembly into the rectangular hole as the cap is tight-
ened. | Be sure that the brush cap is fully seated in the | Brush Cap |
|
| |
brush | hoider. |
|
4. Repeat the procedure for the ether brush.
\
\,
Brush
20
