Sears 113.23615 OOT

wARNING: To avoid i'njuryfrom accidental starting,

alwwsturn switch:"OFP and unplug power cord ;,

fromoutlet before removing or replacing the blade;

The purpose of the work hold_downfoot isto hold the

work againstthe table so that it:isless likely io liftwith:the

up stroke of the blade, ttshould lie flat on the work with

the front prongs straddling theblade.

1. The work hold-down foot is attached to the blade guard

wire. The height ofthe work hold-down foot is adjusted

by loosening the height adjustment knob and moving

theguide postup or down. The work hold-down foot is

adjusted front to back and left-to-right by loosening the

hold-down knob located on the bracket, as illustrated

2. When the table is tilted, the work hold-down foot can

be adjusted by loosening the height adjustment knob

and adiustingthe foot to the same angle as the table.

Thework hold-downfoot should always be adjusted as

close to the blade as: possible without touching and

positioneddirectly on the surface of the workpiece.

breakage _iScaused by:the following:

';_tensi_n orunde_tension:

;i:_iuse::!i_biade iiife :exiiausted;

;rAggressive_ Feeding of the workpiece into the

:tebygoing too:fast,

OOT

Height

AdjustmentKnob

Hold-Down

Knob _

Hold-Down

Foot

Adjust

Hold-Down

Foot to

Same Angle

as Table

The dust blower will direct air to the most effective point

on the cutting line when the hold down is adjusted. No

adjustment is necessary to the blower.

The blade guard will always be positioned parallel to the

blade. No adjustment is necessary,

i__ iil -- B/oUSter