assembly
An alternate method of mounting is to fasten band saw to a mounting board. The board should be of suf- ficient size to avoid tipping of saw while in use. Any good grade of plywood or chipboard with a 3/4" mini- mum thickness is recommended. (Thinner chipboard can break.) Once the saw is mounted, securely clamp the board to the workbench using "C" clamps.
24" MIN.
±
18" MIN. | 5" |
WARNING: Supporting surface where band saw is mounted should be examined carefully after
mounting to insure that no movement during use can result. If any tipping or walking is noted, secure workbench or supporting
surface before operating band saw.
INSTALLING THE TABLE
1.Loosen the upper slide lock knob and position the upper guide assembly all of the way up. Tighten lock knob.
2.Open the front cover of the saw by pulling forward on the finger hold located on the left side of the band saw.
3.Locate the square hole behind the lower right wheel and insert a
4.Position the
through the curved slot in the trunnion. The trun-
nion should engage the curved mounting rib on the back side of the saw.
5.Install the 1" outside diameter washer and table
lock knob to the end of the bolt and tighten by hand.
Upper Slide
Lock Knob
Upper
Guide
Assembly
Finger
Hold
Table
=L.J
._ Assembly
M
Tonn,on I J
Trunnion Slots
Table Lock
Knob
8
