operation
DUPLICATING FROM A TEMPLATE
Here are instructions for two simpfe projects which wilt
familarize you with making templates, and then duplicating from them.
STARTER PROJECT:
GAVEL AND SOUND BLOCK
1. Remove page 15A | from | this | manual | and | cut | with | ||||
scissors | along | dotted | lines. |
|
|
|
|
|
|
|
NOTE: | The | pattern | for the | handle | is full | size, | however | |||
the overall | length of the | template | must | be | 13 | 1/4 | ||||
inches. | Pay | particular | attention | to | dimensions | of | the | |||
ends of | the template. |
|
|
|
|
|
|
|
| |
2.Glue the full size patterns to a piece of 1/8 inch or 1/4
inch thick tempered hardboard or plywood. Carefully cut them out and smooth up the edges with a file.
3.Glue a straight strip of wood to the template to reinforce it.
The spur center and cup centers of the Lathe should be in alignment,
If the centers are not in line as shown, make the following adjustments.
GAVEL
1/
SOUND BLOCK
3/1E" SETSCREW
WRENCH
a. Make sure the tailstock and ram are Locked when check i ng for alignment.
b. Loosen the screw in the foot, . .TAP the screw to loosen the Iocknut inside.
HEADSTOCK
FOOT
c.Using a 3/16'" setscrew wrench, loosen the setscrew on the back of the headstock. The screw is located about
d.Swing the tailstock so that the two points are in
line, . .tighten the setscrew in the headstock and the tailstock.
5, Attach the pattern to the Brackets. The Round Head Bolts in the top of each Bracket fits into the slot in
each end of the pattern as shown,
6.The centerline of the pattern must be directly in line
with the centedine of the lathe, Use a combination
square to align the centerline of the pattern with the points of the spur and cup centers as shown, Tighten the nuts and bolts securing the pattern to the Bracket,
TAILSTOCK
8CREW
POINT OF
SPUR CENTER
/
REINFORCINGSTR_P
17
