Sears 113.24907 /

operation

10, Insert a screwdriver into one of the slots in the backing

to prevent it from turning while unscrewing the

workpiece.

! 1. Glue a piece of felt to the bottom to prevent marring

the furniture surface,

CONE POINT

SET SCREW

t. Two Spindle Brackets are provided for duplicating from

an existing spindle.

2. To bold an existing spindle, screw a1-1/4 inch long

Cone-Point Set Screw into each Spindle Bracket and

secure with a Plain Hexagon Nut as shown.

PLAIN HEXAGON NUT

SPINDLE BRACKET

Attach a Spindle Bracket to the felt-hand Bracket using

two 3/4 inch plain Round-Head Bolts, Washers, and

plain Hexagon Nuts as shown.

Be certain the spur and cup centers of the Lathe are in

alignment see page 15step 4.

Before attaching the right-hand Spindle Bracket, align

the left-hand Cone-Point Set Screw with the Point of

the cup center, To do so:

a. Remove the left Tie Rod from the Copy-Crafter.

b. Place the Clamp Plate or a piece of plywood across

the Vertfcat Channels to support a combination

square.

c. Move the taifstock next to the Headstock as shown

and align the point of the Set Screw with the point

of the cup center.

d. Without moving the Spindle Bracket, tighten the

nuts and botts securing it to the left-hand Bracket.

ALIGN SET SCREW

W_TH THE POINT OF

THE CUP CENTER