19.NEVER STAND ON TOOL

Serious injury could occur if the tool is tipped.

Do not store materials above or near the tool such that it is necessary to stand on the tool to reach them.

20.CHECK DAMAGED PARTS

Before further use of the tool, a guard or other part that is damaged should be care-

fully checked to ensure that it will operate properly and perform its intended function. Check for alignment of moving parts, binding

of moving parts; breakage of parts, mount-

ing, and any otherconditions that may affect its operation. A guard or other part that is damaged shoutd be properly repaired or replaced.

21.DIRECTION OF ROTATION

Consult owners manual for proper direction of spindle rotation.

22.NEVER LEAVE TOOL RUNNING UN-

ATTENDED

Turn power off. Don't leave tool until it comes to a complete stop.

additionam safety instructions for copy-crafter

Before operating the Copy-Crafter read and understand your Lathe and Copy-Crafter owner's manuals and affixed Warnings.

I, Preparation of workpiece

Before attempting to copy (duplicate) a spindle turning, rough out the workpiece using the conventional lathe tools and lathe tool rest. Use lowest speed when starting - never exceed recommended speed on lathe "spindle speed" chart.

Before attempting to copy (duplicate) a faceplate turning, saw the corners off the workpiece.

2.Do not force the cutting tool into the re- volving workpiece, or attempt to take a heavy cut. This could damage the workpiece or cause it to come out of the lathe. This is

especially true of long workpieces of small diameter.

Always take light cuts and make sure that the centers are seated properly in the work- piece.

. Wear safety goggles at all times. Wear face shield or mask if operation is dusty.

Mount the workpiece (see "Getting to Know Your Copy-Crafter"). Use lowest speed when starting - never exceed recommended speed on Lathe "spindle speed" chart. Use con- ventional lathe tools and toot rest to turn periphery, Use conventional lathe tools and too! rest (or Bowl Turning Tool Rest -

Cat. No. 9-24903) for internal turnings deeper than 3/4 inches.

4.Stop operation immediately if the turning vibrates or if abnormal noise occurs.

5.Tighten all screws, nuts and Iocknuts securely before operating.

6.Note and follow the instructions found on the WARNING label which appears on the flange of the platform channel.

oJ

m___

'I'!I"IP"!,,

i_'"'

, ,,l! ,I,,!,11 ,ll I,

WEAR YOUR

tOGGLES),

I 'l Ill, i, '1'

!111I1'1'11

The operation of any power tool can result in foreign objects being thrown into the eyes, which can result in severe eye damage. Always wear safety goggles complying with ANSI Z87.1 (shown

on Package) before commencing power tool operation. Safety Goggles are available at Sears retail or catalog stores.

Page 3
Image 3
Sears 113.24907 manual Never Stand on Tool, Check Damaged Parts, Never Leave Tool Running UN Attended, Iip, Ill, i 111I1111