installation Step 9
Electrical Requirements
To reduce the risk of electric shock, your garage door opener has a grounding type plug with a third grounding pin. This plug will onlyfit into a grounding type outlet.
If the plug doesn't fit into the outlet you have,
contact a qualified electrician to install the proper outlet.
To avoid installation difficulties, do not run the opener at this time.
To prevent electrocution or fire, installation
and wiring must be in compliance with local electrical and building codes.
Do NOT use an extension cord,
RightWrong
if permanent wiring is required by your local
To make a permanent connection through the 7/8" diameter hole in the top of the opener (according to local code):
*Remove the opener cover screws and set the cover aside.
*Remove the attached
*Connect the black (line) wire to the screw on the brass terminal; the white (neutral) wire to the screw on the silver terminal; and the ground wire to the green ground screw. The opener must be grounded.
*Reinstall the cover.
code, refer to the following procedure:
Permanent
Wiring
Connections
Ground Tab
Green
Ground
Screw
Ground | Btack |
Wire | _ Wire |
WhiteWire
Wire
To avoid installation difficulties, do not run the opener at this time.
2O