installation Section: Pages 12- 27
installation Step 1
Determine Header Bracket Location
Installation procedures vary according to
garage door types. Follow the instructions which apply to your door.
If the header bracket is not rigidly fastened to
a structural support on the header wall or
ceiling, the safety reverse system may not work properly (see page 30). The door might
not reverse when required, and could cause
serious injury or death.The garage door springs, cables, pulleys, brackets and their hardware are under extreme
tension. Do not attempt to loosen, move or adjust them yourself. Serious personal injury or death could result. Call for professional
Finished
VerticaI
HeaderGuideline
Walt
Ceiting
garage door service.
2x4
StructuraI | • Close the door and mark the inside |
| vertical centerline of the garage door. |
| • Extend the line onto the header wall |
| above the door. |
| Remember, you can fasten the |
| header bracket within 2 feet of the |
| left or right of the door center only if |
| a torsion spring or center bearing |
| plate is in the way; or you can attach |
| it to the ceiling (refer to page 14) |
| when clearance is minimal. (it may |
| be mounted on the wall upside down |
| if necessary, to gain approximately |
| 1/2".) |
| If you need to install the header bracket |
| on a 2x4 (on wall or ceiling), use lag |
| screws (not supplied) to securely fasten |
| the 2x4 to structural supports as shown |
| here and on page 13. |
•Open your door to the highest point of travel as shown. Draw an intersecting horizontal line on the header wall 2" above the high point. This height will provide travel clearance for the top edge of the door.
Door clearance brackets are available for sectional doors when headroom clearance is less than 2". See accessory page 38.
| Ceiling |
| ||
| Header |
| ||
| Wall |
| Header | |
,, | 2" | Track | ||
| ||||
|
| _Wall | Track | |
Highest | Point |
| ||
| of TraveI |
| ||
Door |
| _ | Hig_eCtaPe_int | |
|
|
Sectional | door | door | |
with curved | track | with horizontal | track |
Proceed to Step 2, page 14.
12