Sears 139.53535SRT1 Install the Premium Control Console, Hardware Shown Actual Size

installation Step 6

Install the Premium Control Console

Locate the door control within sight of the door at a minimum height of 5 feet where small children cannot reach, and away from all moving parts of the door and door hardware.

The door control is typically attached directly to the wall. If installing into drywall, drill 5/32" holes and use the anchors _rovided. Forpre-wired installations (as in new home construction), Console models may be mounted to a standard single gang box (Figure 2).

1.Strip 1/4" of insulation from one end of the bell wire and connect it to the two screw terminals on

the back of the door control: white to 2, and white/red to 1.

2.Pry off cover along one side with a screwdriver blade (see Figure 1). Fasten with 6ABx1-1/4" self- tapping screws (standard installation) or 6-32x1" machine screws (pre-wired installation) as follows:

•Install bottom screw, allowing 1/8" to protrude above wall surface.

•Position bottom of door control on screw head and slide down to secure. Adjust screw for snug fit.

•Drill and install top screw with care to avoid cracking plastic housing. Do not overtighten.

•Insert top tabs and snap on cover.

3.(For standard installation) Run the bell wire up the wall and across the ceiling to the opener. Use insulated staples to secure the wire in several places. Be careful not to pierce the wire with a staple, creating a short.

4.Connect the bell wire to the terminal screws on the opener panel: white to 2; white/red to 1.

5.Position the antenna wire as shown.

	2-Conductor	Opener
	BeII Wire	Terminal Screws
		Top
Lighted		Mounting
Push	Button	Hole
	/	_TerminaI
		Screws
		iRED
		Bottom
		Mounting
		Hole
	Light	VIEW
	BACK
	Lock
PREMIUM CONTROL	CONSOLE

Do not connect to live electrical wiring. Connect only to 24 Volt low voltage wires. Connection to live wires or higher voltage may cause serious injury from shock, burn or electrocution.

Children operating or playing with a garage door opener can injure themselves or others.

The garage door could close and cause serious injury or death.

install the door control (or any additional push buttons) out of the reach of children and away from all moving parts of the door and door hardware, but where the garage door is visible.

Do not allow children to operate the push button(s) or the remote control(s).

A moving garage door could injure someone under it. Activate the opener only when the

door is properly adjusted, you can see it clearly, and there are no obstructions to door travel.

Hardware Shown Actual Size

			Insulated
Control	Console (std installation)		Staples
Control Console		(pre-wired)	Dry Walt Anchors
Figure	1		Figure 2
REMOVE & REPLACE		COVER	PRE-WIRED
To Replace,		To Remove,	INSTALLATION
insert		Twist
Tabs		Here

24 Vott

2-Conductor Bell Wire

O

[]

18