|
|
| Door without | Track | ||
Before you begin, survey your garage area to |
| FINISHED | CEILING |
|
| |
see whether any of the conditions below | apply |
|
| |||
Support | bracket |
|
| |||
to your installation. |
|
| & fastening |
|
| |
|
|
| hardware | is required. |
|
|
Slack | in chain | tension | See page 17. |
|
| |
|
|
|
| |||
is | normal | when |
|
|
|
|
garage | door is closed. |
|
|
|
| |
Header |
|
|
|
|
|
|
Wall |
|
|
|
|
|
|
Access Door
©
[ | Reversin_ |
| ) between floor and bottom Sensor |
Safety | of door must not exceed 1/4". |
Reversing Sensor |
|
Based on your particular requirements, there are several installation steps which might call for materials and/or hardware not included in the carton.
•Step 1, page 13 - Look at the wall or ceiling above the garage door. The header bracket must be securely fastened to structural supports.
•Step 5, page 17 - Do you have a finished ceiling in your garage? If so, a support bracket and additional fastening hardware (not supplied) may be required.
•Safety reversing sensor, page 21 - Depending on garage construction, wood blocks may need to be
securely fastened to mounting locations before sensors are installed.
•Step 10, page 22 - Alternate floor mounting of the safety reversing sensor will require hardware that is not provided.
•Step 11, page 25 - Generally, a
•Step 11, page 25 - Depending on your door's construction, you might need additional mounting hardware for the door bracket.
•Do you have an access door in addition to the garage door? If not, Model 53702 Emergency Key Release is required. See page 38.
•The gap between the bottom of the garage door and the floor cannot exceed 1/4".
Otherwise, the safety reverse system may not work properly. See page 30. The floor or the door should be repaired.
Closed Position
Cable
Pulley Bracket
Cable Trolley
\Header Bracket
Door Bracket
|
| Emergency | |
Straight | Curved | Release | |
Rope & Handte | |||
Door | Door | ||
| |||
Arm | Arm |
|
Door
One=Piece Door with Track
| Floor | must | be tevel |
| Reversing | |
Safety | across | width | of door |
| Sensor | |
|
|
|
|
|
| |
Reversing |
|
|
|
|
| |
Sensor |
|
|
|
|
|
|
| Closed | Position |
|
| ||
| Cable | Cable | Trotley |
| Chain | |
Pulley Bracket |
| I | I |
|
| |
| HeaderCorved | I | I | |||
| Bracket UoorArm_/ |
| ||||
| ooooooooooo_j | I |
| |||
|
|
| E |
| I EmergencyRelease | |
| _Door | Straight | _- | Rope & Handle | ||
Door | Bracket | Door |
|
|
| |
| Arm |
|
|
|
You may find it helpful to refer back to this page
as you proceed with the installation of your
opener.