Sears 139.53535SRT1 not suppfied to securely fasten the 2x4 to structural, supports as shown

Read the Safety instructions on page 12. They also apply to doors without tracks.

Header Wall

VerticaI

Centerline

2x4

*Close the door and mark the inside vertical centerline of

your garage door. Extend the line onto the header wall above door.

If headroom clearance is minimal, you can install the header bracket on the ceiling. See page 14.

,If you need to instafl the header bracket on a 2x4 (on waft or ceiling), use lag screws

(not suppfied) to securely fasten the 2x4 to structural

supports as shown.

Header Walt

jJ

Highest Point

of TraveI

Door 1

OPTIONAL CEILING MOUNT

FOR HEADER BRACKET

Header	Highest Point
Wall	of Travel

T

Door

C3

Jamb

Hardware

One-piece door without track jamb hardware

•Open your door to the highest point of travel as shown. Measure the distance from the top of the door to the floor. Subtract the actual height of the door. Add 8" to the remainder. (See Example).

•Close the door and draw an intersecting horizontal line on the header wall at the determined height.

If the total number of inches exceeds the height available in your garage, use the maximum height possible, or refer to page 14 for ceiling installation.

One-piece door without track pivot hardware

EXAMPLE
Distance from top of door
(at highest point of travel)	to floor	92"
Actual height of door		-88"
Remainder		4"
Add		+8"
Bracket height on header	wall	=12"

(Measure UP from top of CLOSED door.)

Proceed to Step 2, page 14.

13