Optional Accessory Installation — Priority Page Sensor Kit
The Priority Page Sensor Kit momentarily silences classroom audio whenever a page is made from a public address (PA) system.
For detailed information, see the Priority Page Sensor Kit Installation Instructions, supplied with the device.
NOTE: The Priority Page Sensor works with traditional 25 V or 70 V and 4/8 ohm PA systems. It is not |
designed for, and may not work properly with, |
digital clocks. |
Priority Page Sensor Kit Included Parts:
•Priority Page Sensor
•
•35 feet. (10.7 m) of sensor cable
Installation Procedure
WARNING: RIsk of serious personal injury if installation is not done correctly. All structural steps,
anchoring, and electrical installation should be performed by qualified personnel in accordance with local and national building codes, fire and safety codes, and/or local and national electrical codes.
To meet the plenum rating requirement, the Priority Page Sensor assembly must be installed in a 
1. Choose a suitable location for the sensor near, |
and in series with, the speakers. |
2. If the sensor is to be located in a plenum |
space, the junction box (provided) can be |
used. Knock out an opening at one end of the |
box and attach the cable clamp (see figure at |
right). Secure the box at the sensor location. |
3. Disconnect the PA system speaker cable from the |
speaker. |
Remove the outer protective jacket from the |
speaker cable to expose the two speaker wires |
from the sensor to the speaker (as shown at right). |
Do not remove the inner protective jackets that |
Cable Clamp
B UL-Compliant Junction Box and Cover
cover the individual wires. |
If the sensor is to be located in a plenum space, |
feed a loop of one of the exposed speaker wires |
through the cable clamp into the junction box. |
The other wire must bypass the sensor to be |
connected later directly to the speaker. |
4. Open the top of the Priority Page Sensor and loop |
the speaker wire that is inside the junction box |
tightly around the top part of the sensor. |
NOTE: Loop only one of the speaker wires |
around the sensor cover. Do not loop both |
wires. Polarity need not be observed. |
The other speaker wire must bypass the sensor and connect directly to the speaker.
Speaker Cable with Plenum Jacket Intact
Open the
Page Sensor
Strip plenum jacket from speaker cable to reveal two speaker wires.
Priority
Page
Sensor
Ceiling Mounted
Paging Speaker
•For a 25 V or 70 V system, wrap 5 to 8 loops.
•For a 4/8 ohm system, wrap 2 to 4 loops.
D Open the sensor and loop a wire around the
sensor.
PoleVault IP Systems • Optional Accessories | 45 |
