Sears 139.53968SRT Example, Proceed toStep, One-piece door without track jamb hardware

ONE-PIECE DOOR WITHOUT TRACK

1.Close the door and mark the inside vertical

centerline of your garage door. Extend the line onto the header wall above door, as shown.

If headroom clearance is minimal, you can install the header bracket on the ceiling. See page 14.

If you need to install the header bracket on a 2x4 (on wall or ceiling), use lag screws (not provided) to securely fasten the 2x4 to structural supports as shown.

2.Open your door to the highest point of travel as shown. Measure the distance from the top of the door to the floor. Subtract the actual height of the door. Add 8" to the remainder. (See Example).

3.Close the door and draw an intersecting horizontal line on the header wall at the determined height. NOTE: If the total number of inches exceeds the height available in your garage, use the maximum height possible, or refer to page 14 for ceiling installation.

EXAMPLE
Distance from top of door
(at highest point of travel) to floor	92"
Actual height of door	-88"
Remainder	4"
Add	+8"
Bracket height on header wall	=12"
(Measure UP from top of CLOSED door.)

Proceed toStep _ page 14.

Header Wall

Unfinished

Ceiling

Vedical

Centerline

CEILING MOUNT

FOR

HEADER BRACKET

Header Wall

/Highest Point of Travel

"7

Q

One-piece door without track: jamb hardware

Floor

One-piece door without track: pivot hardware

13