Sears 139.53968SRT owner manual Attach the Emergency Release Rope and Handle, Lens Guide, Overhand

INSTALLATION STEP 7

Install the Light and Lens

•Install a 75 watt maximum light bulb in the socket. The light will turn ON and remain lit for approximately 4-1/2 minutes when power is connected. Then the light will turn ore

•Apply slight pressure on the sides of the lens and slide the tabs into the slots in the end panel. (See illustration .)

•For convenience, the lens may be installed after Adjustment Step 4 on page 30.

•To remove, reverse the procedure. Use care to avoid snapping off lens tabs.

•Use standard neck Garage Door Opener bulbs for replacement.

Light

Lens I

I*"	Lens
" .	Guide
_g._	Lens
ens	Light Bulb
Tab

INSTALLATION STEP 8

Attach the Emergency Release Rope and Handle

•Thread one end of the rope through the hole in the

top of the red handle so "NOTICE" reads right side up as shown. Secure with an overhand knot at

least 1" from the end of the rope to prevent slipping.

•Thread the other end of the rope through the hole in the release arm of the outer trolley.

•Adjust rope length so the handle is 6 feet above the floor. Secure with an overhand knot,

NOTE: flit is necessary to cut the rope, heat seal the cut end with a match or lighter to prevent

unraveling.

•To preventpossibleSERIOUSINJURYor DEATHfrom a falling garagedoor:

-If possible,useemergencyreleasehandleto disengagetrolley ONLYwhen garagedoor is CLOSEDWeakor. brokenspringsor unbalanced door couldresult in anopendoor fallingrapidly and/or unexpectedly.

-NEVERuseemergencyreleasehandleunlessgarage doorwayis clearof personsandobstructions.

•NEVERuse handleto pull door openor closed,If rope knot becomesuntied,you could fall.

Trolley

Trolley

Overhand

Eme_gencKnot

Release Handle

19