Sears 149.23632 Installing the JOINTER--PLANER, Controls and Adjustments, Depth of CUT Hand Knobs

INSTALLING THE JOINTER--PLANER

If the Jointer-Planer is to be used in a permanent location, it should be fastened securely to a firm supporting surface such

as a workbench. Holes should be drilled through supporting surface of the workbench as illustrated. Each foot of the Jointer- Planer should be bolted securely using 5/16" diameter machine bolts, 5/16" hex nuts, and lock washers. Bolts should be of sufficient length to accommodate foot of Jointer-Planer, washer, hex nuts, and thickness of supporting surface. Tighten all four

bolts securely. If the Jointer-Planer is to be used in a portable application, it is recommended that it be fastened to a mounting board. The board should be of sufficient size to avoid tipping of

Jointer-Planer while in use. Any good grade of plywood or chip-

board with a 3/4" minimum thickness is recommended. Mount

3/8 OlA

4, HOLES

t	I	[ 1
i	i	,q-
I	I	I
--4	+--.

i i

II

Jointer-Planer	to	board	using	hole pattern		as shown.		Clamp	3-1/2--
board securely to workbench or supporting surface.									I	i
Supporting	surface	where	Jointer-Planer		is	mounted	should be
examined carefully after mounting to insure that no movement									24	_
during use	can result. If		any	"tipping"	or	"walking"	is	noted,

secure workbench or supporting surface before operating.

CONTROLS AND ADJUSTMENTS

CAUTION: MAKE SURE THE SWITCH IS OFF AND THE CORD IS UNPLUGGED BEFORE PER- FORMING ANY CHECKS OR ADJUSTMENTS.

2 FENCE

\

3CUTTERGUARD

/

_

/

4 ON-OFF SWITCH

1. DEPTH OF CUT HAND KNOB

Turning the hand knob clockwise raises the infeed table and decreases the depth of cut. Turning it counter-clockwise lowers the infeed table and increases the depth of cut to the maximum !/8" depth per pass.

NOTE: When the table is lowered for the maximum 1/8"

depth cut, the hand knob will be relieved of tension and will be loose. If this is disturbing, simply turn the hand knob clockwise until it is again under tension. Turn the knob no more than 1/2 turn after it is again under tension. This will

not change the depth of cut setting unless 1/2 turn is exceeded.

1DEPTH OF CUT HAND KNOBS

TABLE

OF

CUT HAND

KNOB

8