SAFETY RULES FOR JOINTER--PLANER

Safety is a combination of operator common sense and alertness at all times when the Jointer--Planer is being

used. Study these rules and general safety rules before operating and retain them for future use.

1.WEAR EYE PROTECTION.
2. NEVER MAKE JOINTING OR PLANING CUT DEEPER THAN
1/8INCH -- PER PASS.
3. FEED WORKPIECE AGAINST ROTATION OF CUTTER.
4. KEEP FINGERS AWAY FROM REVOLVING CUTTER -- use
fixtures when necessary.
5. NEVER PERFORM JOINTING OR PLANING OPERATION
WITH CUTTER HEAD GUARD REMOVED.
6. NEVER FORCE CUTTING ACTION. Stalling or partial stalling
of motor can cause major damage. Allow motor to reach full
speed before cutting.
7. NEVER -Attempt to perform an abnormal or little used
operation without study and the use of adequate hold down
/push blocks, jigs, fixtures, stops, etc.
8. NEVER -Attempt to cut small pieces.
9.
10.
11.
12.
ALWAYS -Use hold down/push blocks for jointing material
narrower than 3 inches, or planing material thinner than 3
inches.
ALWAYS- Keep cutter sharp.
NEVER- Use in an explosive atmosphere. Normal sparking of
motor may ignite fumes.
OUTDOOR EXTENSION CORD USE - When tool is used
outdoors, use only extension cords suitable for use outdoors.
Outdoor approved cords are marked with the sL'ffix W-A, for
example- SJTW-A or SJOW-A.
13.ALWAYS use identical replacement parts when servicing.
14.This tool is intended for RESIDENTIAL USE ONLY.
WARNING: DO NOT ALLOW FAMILIARITY (GAINED FROM
FREQUENT USE OF YOUR JOINTER--PLANER) TO BECOME
COMMONPLACE. ALWAYS REMEMBER THAT A CARELESS
FRACTION OF A SECOND IS SUFFICIENT TO INFLICT SEVERE
INJURY.

WARNING: DO NOT AT ANY TIME LET BRAKE FLUIDS, GASOLINE, PENETRATING OILS, ETC.

,_ CONTACT WITH PLASTIC PARTS. THEY CONTAIN CHEMICALS THAT CAN DAMAGE

COME IN

AND/OR DESTROY PLASTICS.

ASSEMBLY

DEPTH OF CUT HAND KNOB

1. Find one 3/8 lockwasher and the depth of cut hand knob from
the parts bag.
2. Turn the nut on the height adjustment screw until five full
threads extend beyond the nut.
3. Place Iockwasher on height adjustment screw and thread
hand knob onto screw.
4. Back nut up against hub of hand knob. Tighten with 14ram or
9/16 wrench while holding hand knob. t
DEPTH OF CUT
HAND KNOB
3/8 HEX NUT

CHIP DEFLECTOR

1. Loosen the screw in the center of vacuum port of chip
discharge.
2. Install slot of chip deflector between the chip discharge and
the flat washer and retighten.
,_CAUTION: THE CHIP DEFLECTOR MUST BE IN PLACE
FOR SAFE OPERATION. FAILURE TO INSTALL THE CHIP
DEFLECTOR MAY RESULT IN PERSONAL INJURY.
LOOSEN AND
RETIGHTEN
TH I S SC R E W _..........._.
DEFLECTOR