11. | Apply grease to a Pedal Arm Axle (64). | 11 |
|
|
|
|
|
| |
| Next, slide an M8 Washer (97) and an Axle |
|
|
|
| Spacer (77) onto an M8 x 13mm Screw (82), and |
|
|
|
| tighten the Screw a few turns into the Pedal Arm |
|
|
|
| Axle (64). |
|
|
|
| While a second person holds the front end of the |
|
|
|
| Right Pedal Arm (58) inside the bracket on the |
|
|
|
| Right Upper Body Leg (60), insert the Pedal Arm |
|
|
|
| Axle (64) into both parts. |
|
|
|
| Slide an M8 Washer (97) and an Axle Spacer | 99 | 60 |
|
| (77) onto another M8 x 13mm Screw (82), and | 82 | Grease |
|
| tighten the Screw a few turns into the Pedal Arm | 97 | 64 |
|
| Axle (64). Then, tighten both Screws at the |
| ||
| 77 | 77 |
| |
| same time. |
| 97 | 82 |
| Repeat this step on the other side of the |
| 58 | |
|
|
| ||
|
|
|
| |
| elliptical. |
|
|
|
| See assembly step 4. Tighten the M10 x 25mm |
|
|
|
| Screws (99). |
|
|
|
12. | Orient the Shield Cover (75) assembly as shown. | 12 |
|
|
|
|
|
| |
| While a second person holds the Shield Cover |
|
|
|
| (75) assembly near the Upright (4), connect the |
| Avoid pinching | |
| Fan Extension Wire (146) to the Fan Wire (136). |
| ||
|
|
| the wires |
|
Tip: Avoid pinching the wires. Press the |
| |
Shield Cover (75) onto the Left and Right Shields | 4 | |
(73, 74). | ||
|
73, 74
146
136
75
11
