Sears 23949 user manual Tip To prevent the wires from falling into, At the same time

5. See the inset drawing. Locate the wire tie in the	5
lower end of the Upright (4). Tie the wire tie to		Wire Tie
the Upper Wire (110) and to the Fan Extension
Wire (146). Then, pull the upper end of the wire		146
tie until the Upper Wire and the Fan Extension		110
Wire are routed through the Upright.
Tip: To prevent the wires from falling into the	146
Upright (4), secure the wires with the wire tie.	110
	Wire	4
	Tie
		146
		110
6. Using a plastic bag to keep your fingers clean,	6
apply some of the included grease to the Pivot
Axle (35) and to two 16mm Wave Washers (54).
Insert the Pivot Axle (35) through the Upright (4)
and center it. Tip: It may be helpful to use a
rubber mallet.	4
Identify the Right Upper Body Leg (60) and
	35	Grease
orient it as shown.		54
Slide a 16mm Wave Washer (54) and the Right
		60
Upper Body Leg (60) onto the right side of the		97
Pivot Axle (35).		82
Repeat these actions for the Left Upper Body	46
Leg (46).
Tighten an M8 x 13mm Screw (82) and an M8
Washer (97) into each end of the Pivot Axle (35)
at the same time.
	8