'
o To Remove the Bobbin from the Machine | o Wind the Bobbin |
f |
|
1.Gently push down on the bobbin cover plate and slide _t towards you.
2.Set astde.
3.Lift out the bobbin, as shown.
NOTE: The bobbin winder stopper can be adjusted for
the amount of thread needed on the bobbin
(example 1/ 2 full or full etc.). To make the
adjustment use your large screw driver and loosen the screw one turn or tess, This will allow
you to adjust the position of bobbin winder stopper. Do not take screw all the wayout.
Ctu[ch
1.Put your spool of thread onto spool pin, with the thread winding in the direction sh own.
2.Putl the clutch away from the machine to stop the needle from moving while you winding the bobbin.
3.Draw thread from spool through bobbin winder tension disc as shown.
4.Place the threaded bobbin on the bobbin winding spindle so that the thread comes out on top,
5.Push the bobbin winder spindle to the right until it clicks.
6.Holding onto end of thread, depress the foot control.
7.When the bobbin is slightly fiIled, stop the machine and clip the thread coming from the bobbtn.
8.Slowly start the machine again and wind the thread until the bobbin stops.
9.Push the bobbin winder spindie to the }eft and clip the thread,
10, Remove the bobbin.
11.Push in the clutch for normal sewing operation.
15
