Sears 46525 To Set Self-Cleancycle, To Interrupt A Clean Cycle, When A Clean Cycle Is Finished

TO SET SELF-CLEAN CYCLE:
1. Close oven door.	Push CLEAN. The time display will	TO INTERRUPT A CLEAN CYCLE:
show (--). See	Fig. 1. You may need to press	1. Push CLEAR/OFF.

slightly on the door.

Follow Instructions under "WHEN A CLEAN CYCLE IS FINISHED."

Fig. 1

2. Press L_ or _ to set the desired length of clean time. Clean time is normally 3 hours. You can change It between 2 and 4 hours, depending on how dirty the oven Is. See Fig, 2, The door locks automatically after the controls are set. The display will show "LOCK" when door locks.

Rg. 2

YOU can push STOP TIME to find out when the cycle will end. Push CLEAN to return to countdown.

WHEN A CLEAN CYCLE IS

FINISHED:

1.Walt until the LOCK display goes out. The oven temperature must drop to a safe level before the door can be opened. See Fig. 3.

WAIT UNTIL LOCK GOES OUT

Fig. 3

If you cannot open the door Immediately after the word LOCK goes off, wait about one minute and try again.

TO SET DELAYED SELF-CLEAN CYCLE:

Follow steps 1-3 under "TO SET SELF.CLEAN

CYCLE," THEN:

4.Press STOP TIME.

5.Set the time of day when you want the clean cycle to end. See Fig. 4.

The control will calculate the start clean time.

Fig. 4

Note: When selecting a stop time for a delayed clean cycle, you must allow time for the 2-4 hour clean time.

Your oven light should be OFF during a self-clean cycle to prolong the life of the bulb.

14 NESCL07-1