EN 43
Master Page: Right-Heading0
FEATURES FOR RECORDING
Once the camcorder is set, the camcorder operator
can become part of the scene in a more natural way,
adding the final touch to a memorable picture.
1Set the Power Switch to “M” while pressing down
the Lock Button located on the switch.
2Open the LCD monitor fully, or pull out the
viewfinder fully.
●You can tilt the LCD monitor upward to 180°
so that it faces forward and view yourself while
self-recording with the viewfinder pushed
back.
3Set “SELF-TIMER” to
“ON ”. (墌pg.35, 37)
4To engage the Self-Timer
for video recording, press
the Recording Start/Stop
Button.
●After 15seconds, the
beep sounds and video
recording starts.
To stop Self-Timer
recording, press the
Recording Start/Stop
Button again.
●The camcorder re-enters
Record-Standby mode.
OR
4Press SNAPSHOT.
●After 15seconds, the beep sounds and
snapshot recording starts. After that, the
camcorder re-enters Record-Standby mode.
5To end Self-Timer recording, select “OFF” in
step3.
NOTE:
If ���BEEP” and “TALLY” are set to “OFF” (墌pg.38),
the beep does not sound and the tally lamp does not
light.
Self-TimerPower Switc h
SNAPSHOT Button
Lock Button
NU
L MA A
OMEL –TI SE F R FF–
NRETUR
ON
Self-Timer indication
When the Recording Start/
Stop Button or SNAPSHOT is
pressed, the tally lamp
changes as shown:
Begins blinking
(Self-Timer starts)
Blinks quickly
(Self-Timer shooting starts
soon)
Stops blinking and stays on
(Self-Timer video recording
starts)
OR
Turns off
(Self-Timer snapshot
recording occurs)
After approx.
15sec.
ADVANCED FEATURES
GR-HD1US.book Page 43 Monday, April 14, 2003 5:21 PM