29.Attach a 3" "U" Bracket (97) to the Front Upright (76) with a 5/16" x 4" Bolt (27), 5/16"
Washer (10) and 5/16" Nylock Nut (4). The Nylock Nut should be threaded onto the Bolt four complete turns. The cabling will be too short If the Nylock Nut Is overtlght- ened.
Wrap the Long Cable (93) around a 4 1/2" Pulley (54) as shown. Attach the Pulley to the
3" "U" Bracket (97) with a 3/8" x 1 3/4" Bolt
(26)and 3/8" Nylock Nut (15).
30.Slide a Plastic Cable Guide (18) and a 3 1/2" Pulley (55) onto a 3/8" x 3 1/2" Bolt (5). Insert the Bolt into the Leg Lever (71). Slide a 3/8"
Washer (8) onto the Bolt and tighten a 3/8" Nylock Nut (15) onto the Bolt.
Pull back the Plastic Cable Guide (18) and wrap the Long Cable (93) around the 3 1/3" Pulley (55). Turn the Plastic Cable Guide so it holds the Cable on the Pulley.
31.Slide a Plastic Cable Guide (18) and a 3 1/2" Pulley (55) onto a 3/8" x 3 3/4" Bolt (21). Insert the Bolt into the tube on the Base (69) and tighten a 3/8" Nylock Nut (15) onto the Bolt.
Pull back the Plastic Cable Guide (18) and wrap the Long Cable (93) under the 3 1/3" Pulley (55). Turn the Plastic Cable Guide so it holds the Cable on the Pulley.
32.Route the Long Cable (93) over the 3 1/2" Pulley (55) at the lower end of the "1" Plates
Slide a Plastic Cable Guide (18) and a 3 1/2" Pulley (55) onto a 3/8" x 3 3/4" Bolt (21). Insert the Bolt into the tube on the Front
Upright (76) and tighten a 3/8" Nylock Nut
(15)onto the Bolt.
Pull back the Plastic Cable Guide (18) and wrap the Long Cable (93) under the 3 1/3"
| Pulley (55). Turn the Plastic Cable Guide so |
12 | it holds the Cable on the Pulley. |
|
29
93
26
3O
31
18
55
2169
15
